Siemens SIMODRIVE 611 universal Function Manual page 61

01.99 08.02
Installing/ An option module is installed/removed from the control board as follows
removing an (refer to Fig. 2-1):
option module
Warning
!
When installing/removing an option module, observe the ESDS
measures.
1. Ensure that the control board is in a no–voltage condition.
2. Removing (changing):
3. Insert the module through the front panel until it latches into place.
4. Tighten up the screws holding the module
5. Connect–up the front panel of the option module corresponding to
...
SIEMENS
SIMODRIVE
Fig. 2-1 Installing the control board and an option module
Note
The PROFIBUS firmware, associated with the 611u firmware must be
available on the PROFIBUS–DP option module. Otherwise the
firmware must be upgraded. PROFIBUS–DP1 option modules from
SW 4.1 – and also in this particular case – can no longer be used.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
2.1 Installing/removing control boards and modules
Release the screws at the slot and withdraw the option module
from the "old" control board.
Installing:
Remove the screws for the cover at the slot for the option module.
(2 screws in the front panel, max. torque = 0.8 Nm).
the connection diagram (refer to Chapter 2.3.3).
The mating connectors are inserted at the appropriate interface.
Power module
"SIMODRIVE 611 universal"
control board
Screw
Memory module
Screw
2 Installing and Connecting-Up
Screw
Optional TERMINAL module
Mounting
or
slot for
Optional PROFIBUS–DP
module
Screw
For screws:
Tighten (due to the shield contact)
Max. torque = 0.8 Nm
2
2-61