Table of Contents
Advertisement
06.04
Information for
using this Manual
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
The following should be observed when using this manual:
1. Help: The following help is available for the reader:
S
Complete table of contents
S
Header line (as orientation):
the main chapter is in the upper header line
the sub–chapter is in the lower header line
S
Chapter list of contents is provided at the beginning of each Chapter
S
Appendix with
– Abbreviations and List of References
– Index
If you require information regarding a specific term, then look for
this in the Appendix under the Chapter "Index".
The Chapter number as well as the page number is specified
where information on this term can be found.
2. Parameter lists
In this description, for the parameters, the following displays and
significances are available:
S
P0660
Parameter 0660 without sub–parameter
S
P1451:8
P1451 with sub–parameters (P1451:0 to P1451:7)
:8
Sub–parameters that are dependent on the
parameter set
S
P0080:64
P0080 with sub–parameters (P0080:0 to P0080:63)
:64
sub–parameters that are dependent on the
traversing block
The following applies:
Colon (:)
the parameter has the sub–parameter
Number:
these sub–parameters are available (from :0)
S
P1650.15
Parameter 1650 bit 15
3. Identifying "new" or "revised" information
The documentation, Edition 01.99 is the first edition.
How is the "new" or "revised" information identified for the other edi-
tions?
S
"from SW x.y" is provided with the information.
S
The edition is in the header line on this page > 01.99.
Exceptions:
List of faults and warnings, parameter list
The lists are completely updated at each edition, and a new edition
can be entered in the header lines on all of the pages.
For the individual faults and warnings, there is no software release–
dependent coding regarding the parameters.
Foreword
vii
Advertisement
Chapters
Table of Contents
