Siemens SIMODRIVE 611 universal Function Manual page 253

08.99 08.02 05.00
S
Table 5-24 Fault code in Gx_XIST2
Gx_XIST2 Meaning
1 Encoder sum error
hex
2 Zero mark monitoring
hex
3 Abort parking encoder The "parking axis" was already selected.
hex
4 Abort, reference mark
hex
search
5 Retrieve reference
hex
value interrupted
6 Abort, flying measure-
hex
ment
7 Abort, retrieve mea-
hex
sured value
8 Abort absolute value
hex
transmission on
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Error code
Possible causes/description
The fault description should be taken from the following faults (refer
to Chapter 7.3.2):
S
Fault 514
S
Fault 609
S
Fault 512
S
Fault 615
The fault description should be taken from the following faults (refer
to Chapter 7.3.2):
S
Fault 508
S
Fault 514
S
A fault is present (Gx_ZSW.15 = 1)
S
Parking encoder/axis active
S
"Flying measurement" function already active
S
Change of function type
S
No reference marker programmed
S
Hardware already busy with another function
S
Only BERO: BERO not at terminal I0.x
S
Not BERO: EnDat encoder used
S
Invalid combination of reference markers for distance–coded
encoder (1–2, 3–4, 1–2–3–4 are supported)
S
A fault is present (Gx_ZSW.15 = 1)
S
Parking encoder/axis active
S
No reference marker programmed
S
Requested value not available
S
Change of function type
S
A fault is present (Gx_ZSW.15 = 1)
S
Parking encoder/axis active
S
Change of function type
S
Reference point approach still active
S
Measuring probe not at terminal I0.x and measuring probe 1 not
used
S
Hardware already busy with another function
S
Spindle positioning active (P0125=1, from SW 5.1)
S
A fault is present (Gx_ZSW.15 = 1)
S
Parking encoder/axis active
S
Change of function type
S
Requested value not available
S
Not exactly 1 value to be retrieved
S
EnDat encoder not used
5 Communications via PROFIBUS DP
5.6 Net data (PKW and PZD area)
Motor measuring system (encoder 1)
Encoder limiting frequency exceeded
Direct measuring system (encoder 2)
DM encoder limiting frequency exceeded
Motor measuring system (encoder 1)
Direct measuring system (encoder 2)
5
5-253