Siemens SIMODRIVE 611 universal Function Manual page 47

Control components for closed-loop speed control and positioning
Table of Contents

Advertisement

01.99
10.99
! not 611u !
Table 1-5
Overview of the board–specific terminals and interfaces, continued
Terminals
Function
Function
No.
Desig-
nation
663
X431.4
Pulse enable
(+24 V)
19
X431.5
Reference
(Reference for all
digital inputs)
Serial interface (X471)
X471
Serial interface for
"SimoCom U"
PROFIBUS–DP interface (X423) for the optional PROFIBUS–DP3 module
X423
Communications in-
terface for
PROFIBUS
Equipment bus (X351)
X351
Equipment bus
Test sockets (X34)
DAU1
Test socket 1
DAU2
Test socket 2
X34
M
Reference
1) I: Input; S: Supply; IO: Input/output; MA: Measuring signal, analog
2) Can be freely parameterized
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
1.4
"SIMODRIVE 611 universal E" control board
Type
Type
1)
1)
I
Voltage tolerance
(including ripple):
Typ. current consumption:
Note:
The pulse enable acts simultaneously on drive A and
drive B. When this pulse enable is withdrawn, the
drives "coast down" unbraked.
S
Note:
If the enable signals are to be controlled from an exter-
nal voltage and not from terminal 9, then the reference
potential (ground) of the external source must be con-
nected to this terminal.
IO
Connector type: 9–pin D–sub socket connector
Note:
S
The interface can only be used as RS232 interface
––> refer to Chapter 3.3.3
S
Pin assignment of the interface ––> refer to Chap-
ter 2.4
S
Cable diagram for RS232 ––> refer to Chapter 2.5
IO
Connector type: 9–pin D–sub socket connector
Note:
S
Pin assignment of the interface ––> refer to Chap-
ter 2.4
S
Connecting diagram and connecting–up the op-
tional PROFIBUS–DP module ––> refer to Chapter
2.3.4
S
Communications via PROFIBUS–DP
––> refer to Chapter 5
IO
Ribbon cable:
Voltages:
Signals:
2)
MA
Test socket:
Resolution:
Resolution:
2)
MA
Voltage range:
Voltage range:
MA
Maximum current:
1 Product Overview
Technical data
Technical data
21 V to 30 V
25 mA at 24 V
34–pole
various
various
∅ 2 mm
8 bit
8 bit
0 V to 5 V
0 V to 5 V
3 mA
1
1-47

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simodrive 611 universal e

Table of Contents