Siemens SIMODRIVE 611 universal Function Manual page 8

Foreword
Edition of the
documentation?
Software release of
the board?
What is new?
viii
There is a fixed relationship between the edition of the documentation
and the software release of the control board.
The first edition 01.99 describes the functionality of SW 2.1.
Edition 04.99 describes the functionality of SW 2.x.
What are the essential new functions that have been added for SW 2.x
in comparison to SW 2.1?
S
Rotary axis with modulo correction
S
Motor changeover for induction motors
S
Optional TERMINAL modules can now be used independent of the
operating mode.
S
Communications via the RS485 interface (HW dependent)
S
SimoCom U Comparing parameter sets
S
Example: Drive operated via PROFIBUS
Reading/writing parameters via PROFIBUS
Edition 10.99 describes the functionality of SW 2.x and SW 3.x.
What are the essential new functions that have been added for SW 3.x
in comparison to SW 2.x?
S
Jerk limiting
S
External block change
S
Input signal "Suppress fault 608" (speed controller output limited)
S
Optional PROFIBUS–DP module:
PROFIBUS–DP2, Order No. (MLFB): 6SN1114–0NB00–0AA1
PROFIBUS–DP3, Order No. (MLFB): 6SN1114–0NB01–0AA0
S
PROFIBUS
Process data configuring
Motion Control with PROFIBUS–DP (clock synchronous operation)
New control signals:
New status signals:
Override evaluation can be set (P0883)
S7 blocks to read/write parameters
S
Fixed speed setpoints for closed–loop speed controlled operation
S
2
i t power module limiting
S
SimoCom U Online operation via PROFIBUS possible
Online operation via MPI interface possible
PROFIBUS diagnostics screen
Help topics for each parameter of the expert list
S
Faults and warnings:
The stop response (STOP I to STOP VII) is specified for each one
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
NSOLL_B, DIG_OUT, Gx_STW
NIST_B, DIG_IN, XistP, IqGl,
Gx_ZSW, Gx_XIST1, Gx_XIST2
E Siemens AG 2005 All Rights Reserved
06.04