Siemens SIMODRIVE 611 universal Function Manual page 152

4 Commissioning
4.7 Induction motor operation with induction motor
Table 4-7 Parameter overview for IM operation (encoderless operation)
No.
1451:8 P gain, speed controller IM (ARM)
... the P gain of the speed controller in IM operation is set (operation without encoder).
Note:
The parameter is preset when executing the "calculate controller data"/"calculate unlisted
motor" function.
1453:8 Integral action time, speed controller IM
(ARM)
... the integral action time of the speed controller is set in IM operation (operation without en-
coder).
Note:
The parameter is preset when executing the "calculate controller data"/"calculate unlisted
motor" function.
1458 Current setpoint open–loop controlled
range IM (ARM)
For pure IM operation (P1465 = 0), the drive is open–loop, current–frequency controlled below
the changeover speed (P1466).
In order to be able to accept a higher load torque, the motor current in this range can be in-
creased using P1458.
Note:
This is entered as a percentage of the rated motor current (P1103).
The current is limited to 90% of the current limit value (P1238).
1459 Torque smoothing time constant AM (ARM)
... the pre–control value for the torque is smoothed (initial rounding–off).
Note:
In IM operation, a speed–torque–frequency pre–control is implemented due to the low dynamic
performance.
1465 Changeover speed MSD/IM (ARM)
Above this, the drive runs, in IM operation with the speed set in this parameter.
P1465 = 0
P1466 < P1465 < n
P1465 > n
max
Note:
S
When IM operation is selected, only pulse frequencies (P1100) of 4 and 8 kHz are permissi-
ble.
S
The parameter is preset to 0 when first commissioning, if there is no motor measuring
system (P1006 = 98, P1027.5 = 1).
1466 Changeover speed, closed–loop/open–
loop control IM (ARM)
For pure IM operation (P1465 = 0), the drive is open–loop, current–frequency controlled below
the speed set using this parameter.
Note:
The parameter is preset when executing the "calculate controller data"/"calculate unlisted
motor" function.
4-152
Parameters
Name
pure IM operation
mixed operation, MSD/IM
max
only MSD operation
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Min. Standard Max.
0.0 0.3 9 999.999 Nms/rad Imme-
0.0 140.0 6 000.0
0.0 90.0 150.0
0.0 4.0 100.0
0.0 100 000.0 100 000.0 RPM
150.0 300.0 100 000.0 RPM
E Siemens AG 2005 All Rights Reserved
01.99
Units Effec-
tive
diately
ms Imme-
diately
% Imme-
diately
ms Imme-
diately
Imme-
diately
Imme-
diately