Siemens SIMODRIVE 611 universal Function Manual page 236

5 Communications via PROFIBUS DP
5.6 Net data (PKW and PZD area)
Status word
MeldW
Table 5-17 Status word MeldW
Spindle position reached (spindle position 2, from SW 5.1)
Position reached (spindle position 1, from SW 5.1)
Bit 15 14 13
Heatsink temperature pre–warning
Motor overtemperature pre–warning
Note:
From the perspective of SIMODRIVE 611 universal, status signals are output signals and are described
in Chapter 6.4.6.
Also refer in the index under "Output signal, digital ...").
Status word ADU1
ADU2
5-236
Pulses enabled (from SW 3.1)
Reserved
Reserved
Power module current not limited (from SW 3.1)
Reserved
12 11 10 9
Variable signaling function
DC link monitoring V
The actually converted values of the 2 analog inputs of a drive are dis-
played using these status words.
Status word Analog input
ADU1 X451
ADU2 X451
Note
The parameters available to parameterize the analog inputs are still
valid (refer to Chapter 6.6).
Data transfer format:
Update rate at which this signal is provided:
S
Clock–cycle synchronous PROFIBUS–DP
––> generally: DP clock cycle, sensed at instant in time T
S
non–clock–cycle synchronous PROFIBUS–DP
––> n–set mode:
––> pos mode:
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
ZSW
n = n
set act
8 7 6 5 4
> V
DC link x
| n | < n
act
| n
act
Ramp–up completed
ADU ADU
1 2
terminal 56.x/14.x
terminal 24.x/20.x
8 10 V
4000
hex
Position controller clock cycle (P1009)
Interpolation clock cycle (P1010)
E Siemens AG 2005 All Rights Reserved
07.03 08.99
Meld
2 W
3 2 1 0
x
| < n
min
| M | < M
x
i