Siemens SIMODRIVE 611 universal Function Manual page 678

7 Fault Handling/Diagnostics
7.3 List of faults and warnings
708
Cause
Remedy
Acknowledgement
Stop response
709
Cause
Remedy
Acknowledgement
Stop response
710
Cause
Remedy
Acknowledgement
Stop response
716
Cause
Remedy
Acknowledgement
Stop response
7-678
Axial deviations in current controller cycle
On a 2-axis module, the current controller cycle is different for both
axes.
Check P1000 and set the input values the same for both drives.
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Axial deviations in speed controller cycle
On a 2-axis module, the speed controller cycle is different for both
axes.
Check P1001 and set the input values the same for both drives.
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Axial deviations in position controller or interpolation
cycle
For a 2-axis module, the position controller clock cycle (P1009) or the
interpolation clock cycle (P1010) is different for the two axes.
Check P1009/P1010 and set the input values for both drives the same.
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Invalid torque constant
The ratio between the rated torque and rated current (torque constant
[Nm/A]) in P1113 is incorrect (less than/equal to zero) or the ratio
P1113/P1112 is greater than 70.
Enter the valid torque/current ratio for the motor used in P1113 or enter
a permissible ratio of P1113/P1112.
Third-party motor:
The torque constant should be determined from the motor data sheet.
Siemens motor:
The torque constant is defined by the motor code (P1102).
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
E Siemens AG 2005 All Rights Reserved
04.05 01.99