Siemens SIMODRIVE 611 universal Function Manual page 819

01.99 04.05
! 611ue diff !
1151 Reset time flux controller (ARM)
Min Standard
0.0 10.0
1160 Threshold speed flux sensing (ARM)
Min Standard
200.0 1500.0
1161 Fixed DC link voltage
Min Standard
0 0
... a fixed DC link voltage can be entered.
> 0 Fixed DC link voltage, the measurement in P1701 (DC link voltage) is inactive
0 The measurement in P1701 is active
The fixed DC link reference is calculated in instead of the measurement:
– DC link adaption
– Flux sensing (ARM)
– Field weakening and stall torque (ARM)
Note:
The DC link is measured in the I/R module, and is transferred as analog signal to the
"SIMODRIVE 611 universal" via the unit bus for evaluation.
1162 Min. DC link voltage
Min Standard
0 0
... defines the permissible DC link voltage lower limit. Fault 616 is output if this limit is fallen be-
low.
1163 Max. DC link voltage
Min Standard
0 800
... defines the permissible DC link voltage upper limit. Fault 617 is output if this limit is ex-
ceeded.
1164 Hysteresis, DC link monitoring
Min Standard
0 50
... defines the hysteresis for the DC link voltage monitoring. This parameter refers to parameter
1162..
1170 Pole pair width (SLM)
Min Standard
0.0 72.0
The pole pair width of a linear drive corresponds to the length from a north and south pole of
the magnet.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Max Unit
500.0 ms
Max Unit
100000.0 rpm
Max Unit
700 V(pk)
Max Unit
800 V(pk)
Max Unit
800 V(pk)
Max Unit
600 V(pk)
Max Unit
1000.0 mm
A.1 Parameter list
Data type Effective
Floating Point immed. (ARM)
Data type Effective
Floating Point immed. (ARM)
Data type Effective
Unsigned16 immed.
Data type Effective
Unsigned16 immed.
Data type Effective
Unsigned16 immed.
(–> 8.1)
Data type Effective
Unsigned16 immed.
Data type Effective
Floating Point PO (SLM)
A Lists
A
A-819