Siemens SIMODRIVE 611 universal Function Manual page 48

1 Product Overview
1.4 "SIMODRIVE 611 universal E" control board
Drive–
specific
terminals
Table 1-6 Overview of the drive–specific terminals
Terminals
Drive A Drive B
No. Desig- No.
nation
Encoder connection (X411, X412)
– X411 –
– – –
Analog outputs (X441)
75.A X441.1 –
16.A X441.2 –
– – 75.B
– – 16.B
15 X441.5 15
1) I: Input; AO: Analog output
2) Can be freely parameterized
3) The analog outputs (X441) should be connected through a terminal strip.
A shielded cable should be used together for all of the analog outputs together between X441 and the
terminal strip. For this cable, the shield must be connected at both cable ends.
The 4 analog cables can be routed away from the terminal strip. The shield of the cables must be
connected and the ground cables must be connected to a common ground terminal.
1-48
The drive–specific terminals are available for both drive A and drive B.
Function
Desig-
nation
– Motor encoder
connection, drive A
X412 Motor encoder
connection, drive B
or
connection, direct
measuring system
(from SW 3.3)
– Analog output 1
– Analog output 2
X441.3 Analog output 1
X441.4 Analog output 2
X441.5 Reference
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Type Technical data
1) 1)
I Reference:
/PJU/ SIMODRIVE 611,
Configuration Manual, Drive Convert- Configuration Manual, Drive Convert-
I
ers, Chapter "Indirect and direct posi-
tion sensing"
Encoder limit frequencies:
S
Enc. with sin/cos 1Vpp: 350 kHz
S
Resolver:
2)
AO Connector type: 5–pin conn. strip
Wiring: Wiring:
2) Max. conductor cross–section
AO
for finely–stranded or solid conduc-
tors: 0.5 mm tors: 0.5 mm
2)
AO
Voltage range:
Max. current: Max. current:
2)
AO
Resolution:
Update: In the speed–controlled clock Update: In the speed–controlled clock
cycle
–
Short–circuit proof
E Siemens AG 2005 All Rights Reserved
08.01 01.99 10.99
! not 611u !
432 Hz
3)
refer to refer to
2 2
–10 V to +10 V
3 mA 3 mA
8 bit