Table of Contents
Advertisement
01.99
08.02
3.3
Parameterizing using the parameterizing and start–up tool SimoCom U
Note
Going online/offline in cyclic operation via PROFIBUS:
While PROFIBUS is in cyclic operation, SimoCom U with CPxx
can be attached or disconnected from the fieldbus via the following
plug–in cable without creating a fault
Order No. (MLFB):
Prerequisites with
In order to go online with a drive using "SimoCom U" via an OPC
the OPC server
server PROFIBUS–DP, the OPC server must first be installed accor-
(from SW 6.1)
ding to the manufacturers instructions and the following prerequisites
must be fulfilled:
S
S
Note for the reader
Please refer to the documentation of the appropriate manufacturer
regarding information on how to configure a PROFIBUS card and OP
server. These procedures depend on the particular manufacturer.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
6ES7901–4BD00–0XA0 (plug–in cable)
Hardware
– PROFIBUS card must be installed in the PC – cards from third–
party manufacturers can also be used
– Connecting cable
Software
– Driver software and the associated OPC server for the installed
Profibus card
– Configuring software for the OPC server
Most OPC server/Profibus cards require a bus setting (e.g. baud
rate, protocol) – several also require that the existing drives are
configured on the bus.
– The OPC server, provided by the manufacturer, offers a possibil-
ity of accessing MSAC2 services according to DPV1 (EN50170)
including the DataTransport service.
OPC servers that have registered themselves with the system
under the Category "Profibus–DPV1–OPC server Version 1.0"
fulfill this requirement.
When selecting the interface, SimoCom U offers this OPC server
in a separate selection box.
3 Parameterizing the Board
3-111
3
Advertisement
Chapters
Table of Contents
