Siemens SIMODRIVE 611 universal Function Manual page 433

01.99 08.01
Table 6-39 Overview: Position reference value interface
Features
Can be switched–in/out
Superimposed motion
Autonomous motion
Possible position refer-
ence value source
Parameterize the angular
incremental encoder in-
terface as output terface as output
P0890 = 1
Output pos. actual values
Parameterize the angular
incremental encoder in-
terface as input
P0890 = 2
Receive position refer- Receive position refer-
ence values
Parameterize PROFIBUS
interface as input
Referencing for incre-
mental measuring sys-
tems
Available in the operating
mode
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
S
Activated via input signal "activate coupling" and "activate coupling via
I0.x" or PROFIBUS bit PosStw.4
P0410 = 1 Speed–synchronous
P0410 = 2 Position–synchronous
P0410 = 7 To the absolute position of the master drive from + P0412
(from SW 4.1)
S
via a traversing block with the COUPLING_IN or COUPLING_OUT com-
mand
P0410 = 3 Speed–synchronous
P0410 = 4 Position–synchronous
P0410 = 8 To the absolute position of the master drive from + P0412
(from SW 4.1)
S
via the traversing block with the COUPLING_IN or COUPLING_OUT
command and queue functionality (being prepared)
P0410 = 5 Speed–synchronous
P0410 = 6 Position synchronous + P0412
Yes, via traversing blocks with the coupling switched–in
Yes, via traversing blocks with the coupling switched–out
S
Angular incremental encoder interface switched as input
S
Drive A (for an internal coupling)
S
PROFIBUS–DP master (from SW 4.1)
S
PROFIBUS–DP slave (slave–to–slave communications) (from SW 4.1)
S
P0892 Factor, angular incr. enc. pulse no./enc. pulse no.
S
P0893 Angular incremental encoder zero pulse offset
––> Refer to Chapter 6.8.1 ––> Refer to Chapter 6.8.1
S
P0891 Source, external position reference value
S
P0894 Angular incremental encoder input signal waveform
S
P0895 External position reference value – No. of increments
S
P0896 Ext. position reference value – No. of dimension
system grids system grids
S
P0897 Inversion, external position reference value
S
P0401 Coupling factor, revolutions master drive
S
P0402 Coupling factor, revolutions slave drive
––> Refer to Chapter 6.8.2
S
P0891 Source, external position reference value
S
P0895 External position reference value – No. of increments
S
P0896 Ext. position reference value – No. of dimension
system grids system grids
S
P0897 P0897 Inversion, external position reference value Inversion, external position reference value
S
P0898 Modulo range, master drive
S
P0401 Coupling factor, revolutions master drive
S
P0402 Coupling factor, revolutions slave drive
Required, if autonomous or superimposed motion has to be executed via
traversing blocks
––> Refer to Chapter 6.2.4
"Positioning" (P0700 = 3)
6 Description of the Functions
6.3 Axis couplings (from SW 3.3)
Description
6
6-433