Table of Contents
Advertisement
7 Fault Handling/Diagnostics
7.3
List of faults and warnings
041
Cause
Remedy
Acknowledgement
Stop response
042
Cause
Remedy
Acknowledgement
Stop response
043
Cause
Remedy
Acknowledgement
Stop response
044
Cause
Remedy
Acknowledgement
Stop response
7-636
The firmware does not support the option module.
Suppl. info: \%u
Supplementary info = 1:
An option module is inserted (P0872) or parameterized (P0875), which
is not supported by the firmware release of the control module.
Supplementary info = 1:
– Upgrade the firmware
– Use a legal option module
– Cancel the option module with P0875 = 0
Supplementary info = 2:
– Use a permissible option module (DP3)
– Cancel the option module with P0875 = 0
Supplementary info = 3:
– Replace the option module hardware DP1 by option module DP2 or
DP3, without changing the drive parameters and the master
configuring. The parameter for the expected option module remains
at P0875 = 2.
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Internal software error. Supplementary info \%u
There is an internal software error.
Supplementary information: only for siemens-internal error diagnostics
– Execute POWER ON-RESET (press button R)
– Re-load the software into the memory module (execute software up-
date)
– Contact the Hotline
– Replace control module
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Firmware, option module
The option module does not contain the currently required firmware.
Use a module with suitable firmware or upgrade the firmware
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
Connection to the option module failed. Supplemen-
tary info \%X
The BUS coupling has failed.
– Execute POWER ON-RESET (press button R)
– Replace option module
POWER ON
STOP II (SRM, SLM) STOP I (ARM)
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
E Siemens AG 2005 All Rights Reserved
04.05
01.99
Advertisement
Chapters
Table of Contents
