Siemens SIMODRIVE 611 universal Function Manual page 495

01.99 06.04 08.01
! 611ue diff !
Table 6-45 List of input signals, continued
Signal name, description
Activate MDI (from SW 7.1)
1 signal The MDI function is activated.
0 signal The MDI function is not activated.
Note:
If MDI is switched–in with the traversing program active, or is switched–out while the traversing block is
running, alarm 144 is initiated which interrupts the traversing program/traversing block.
Activate angular incremental encoder, handwheel
(from SW 8.1)
1 signal The angular incremental encoder handwheel function is activated.
0 signal The angular incremental encoder handwheel function is not activated.
Note:
S
If the input signal "jogging 1 ON/jogging 1 OFF" or "jogging 2 ON/jogging 2 OFF" and "activate angu-
lar incremental encoder, handwheel" are switched–in, Alarm 121 is output.
S
The "angular incremental encoder, handwheel" function is described in Chapter 6.8.
Angular incremental encoder handwheel evaluation,
bit 0 (from SW 8.1)
Angular incremental encoder handwheel evaluation,
bit 1 (from SW 8.1)
The factors entered using parameter P0900 are calculated–in using these 2 input signals.
Ang. incr. enc. hwh. eval.
Bit 0
Bit 1
Note:
––> refer under the index entry "Angular incremental encoder interface"
Ramp–function generator start/ramp–function gen-
erator stop
1 signal The ramp–function generator is enabled
0 signal The setpoint at the ramp–function generator output is frozen
Enable setpoint/inhibit setpoint
1 signal Enable setpoint
The setpoint at the ramp–function generator input is enabled.
0 signal Inhibit setpoint
The setpoint at the ramp–function generator input is set to zero.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
6.4 Input/output terminals of the control board
Fct. No.
83
84
85
86
1 10 100 1000 (standard setting)
0 1 0 1
0 0 1 1
–
–
6 Description of the Functions
Operating
mode
n–set pos PROFIBUS bit
– x SatzAnw.15
– x SatzAnw.13
– x SatzAnw.11
– x SatzAnw.12
x – STW1.5
x – STW1.6
6
6-495