Siemens SIMODRIVE 611 universal Function Manual page 706

7 Fault Handling/Diagnostics
7.3 List of faults and warnings
843
Cause
Remedy
Acknowledgement
Stop response
845
Cause
Remedy
Acknowledgement
Stop response
849
Cause
Remedy
Acknowledgement
Stop response
850
Cause
Remedy
Acknowledgement
Stop response
864
Cause
Remedy
Acknowledgement
Stop response
7-706
Search velocity too high
The search velocity for spindle positioning is too high for the selected
maximum deceleration.
Reduce search velocity P0082:64 or increase the maximum decelera-
tion P0104.
not required
STOP VII
Jogging not effective for active coupling
Jogging is not possible while a coupling is closed.
Release the coupling and re-activate jogging.
not required
STOP VII
PLUS software limit switch actuated
For a block with the ENDLOS_POS command, the axis has actuated
the plus software limit switch (P0316) for absolute or relative position-
ing.
The behavior for software limit switch reached, can be set using
P0118.0.
– Move away in the negative direction, jogging.
– Move away in the negative direction using the traversing block.
not required
STOP VII
MINUS software limit switch actuated
For a block with the ENDLOS_NEG command, the axis has actuated
the minus software limit switch (P0315) for absolute or relative position-
ing
The behavior for software limit switch reached, can be set using
P0118.0.
– Move away in the positive direction, jogging.
– Move away in the positive direction using the traversing block.
not required
STOP VII
Parameterization error in speed controller adaptation
The upper adaption speed (P1412) was parameterized with a lower
value than the lower adaption speed (P1411).
P1412 must contain a higher value than P1411.
not required
STOP VII
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
E Siemens AG 2005 All Rights Reserved
04.05 01.99