Siemens SIMODRIVE 611 universal Function Manual page 846

A Lists
A.1 Parameter list
1717 Limiting factor for torque/power (ARM SRM)
Limiting factor for force/power (SLM)
Min Standard
– –
... displays the actual limiting factor for torque/power or force/power (SLM).
Note:
refer to the index entry "Torque/power reduction"
1718 Torque-generating current Iq (A)
Min Standard
– –
... displays the torque-generating current Iq as RMS value.
Note:
The display of the torque-generating current actual value is smoothed using a PT1 filter
(P1250).
1719 Actual absolute current (rms)
Min Standard
– –
Displays the motor phase current RMS.
1723 Diagnosis, ramp-up time
Min Standard
– –
Note: Internal Siemens
1724 Diagnosis, rotational accuracy monitor
Min Standard
– –
Note: Internal Siemens
1725 Normalization of torque setpoint (ARM SRM)
Normalization of force setpoint (SLM)
Min Standard
– –
– –
... specifies the reference value for the status word Mset for PROFIBUS.
The following applies before SW 4.1: The value corresponds to 800% of the rated motor torque.
From SW 4.1 the following applies: The value corresponds to P0882 * rated motor torque.
1726 Calculated jerk time
Min Standard
– –
... displays the calculated jerk time which is currently effective.
Note: refer to the index entry "Jerk limitation"
1729 Actual rotor position (electrical)
Min Standard
– –
...displays the actual electrical rotor position.
A-846
Max Unit
– %
Max Unit
– A(rms)
Max Unit
– A(rms)
Max Unit
– ms
Max Unit
– –
Max Unit
– N
– Nm
Max Unit
– ms
Max Unit
– Degree
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
! 611ue diff !
Data type Effective
Floating Point RO
Data type Effective
Floating Point RO
Data type Effective
Floating Point RO
Data type Effective
Unsigned16 RO
Data type Effective
Unsigned16 RO
Data type Effective
Floating Point RO
Floating Point RO
Data type Effective
Floating Point RO
Data type Effective
Floating Point RO
E Siemens AG 2005 All Rights Reserved
04.05 01.99
(–> 3.1)
(–> 2.4)
(SLM)
(SRM ARM)
(–> 3.1)
(–> 3.3)