Basic Setting Of The Analog Inputs - Siemens SIMODRIVE 611 universal Function Manual

01.99
! not 611ue !
6.6.1

Basic setting of the analog inputs

Parameter The following functions can be assigned to analog input 1 and 2 of a
overview drive using the appropriate parameterization:
Table 6-51 Parameters for the function of the analog inputs
Analog
input
1 2 No.
0607 Analog setpoint, terminal 56.x/14.x
56 x
The parameter defines whether and how the analog setpoint is used at this analog
–
input.
14 x
= 0
= 1
= 2
0612 Analog setpoint, terminal 24.x/20.x
24 x
The parameter defines whether and how the analog setpoint is used at this analog
–
input.
20 x
= 0
= 1
= 2
Note:
S
x: Space retainer for drive A or B
S
n /M mode:
set set
It is always possible to toggle between n
operation" input signal (refer to Chapter 6.4.2).
0 signal: n mode
set
1 signal: M mode
set
Input terminal I3.x is assigned, as standard, to the "open–loop torque controlled mode" signal.
When toggling between n
at the terminals, becomes immediately effective in the other operating mode.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Parameters
Description
––> off
––> n /M mode (refer to Note)
set set
Velocity override (refer under the index entry "Override")
––> off
––> n /M mode (refer to Note)
set set
––> M mode
red
and M mode using the "open–loop torque controlled
set set
and M mode, it should be noted, that a setpoint, which may be present
set set
6 Description of the Functions
6.6 Analog inputs
Min. Stan- Max. Units
dard
0 1 2 –
0 0 2 –
Ef-
fec-
tive
Im-
medi-
ately
Im-
medi-
6
ately
6-529