Siemens SIMODRIVE 611 universal Function Manual page 551

01.99 06.04 04.99
Table 6-56 Signal selection list for analog outputs, continued
Signal
No. Designation
522 PROFIBUS encoder 2 posi-
3)
tion actual value 1
(G2_XIST1) (from SW 7.1)
523 PROFIBUS encoder 2 posi-
3)
tion actual value 2
(G2_XIST2) (from SW 7.1)
524 PROFIBUS encoder 3 posi-
3) tion actual value 1
(G3_XIST1) (from SW 7.1)
525 PROFIBUS encoder 3 posi-
3) tion actual value 2
(G3_XIST2) (from SW 7.1)
Note:
S
Abbreviations
– rms: rms value
– pk: Peak value
– LSB: Least significant bit
– MSR: Dimension system grid
S
Signal marking?
– Not marked: For SimoCom U, the signal is available as standard
– Marked in gray: For SimoCom U, the signal is only available when the expert mode is activated
1) Dependent on the assignment in P0915:17
2) Dependent on the assignment in P0916:17
3) PROFIBUS signal only supplies a value if it is set in P0615 or P0916.
4) This only applies for spindle positioning
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Operating Displayed Displayed Shift Shift
mode in in fac- fac-
n–set pos
1)
x – P1789:x
1)
x – P1789:x
1)
x – P1789:x
1)
x – P1789:x
6 Description of the Functions
6.7 Analog outputs
Bit Bit Units Units Normaliza- Normaliza-
width width
tor tor (corre- (corre-
sponds sponds
to LSB) to LSB)
8 32 –
8 32 –
8 32 –
8 32 –
tion tion
–
–
–
–
6
6-551