Siemens SIMODRIVE 611 universal Function Manual page 732

A Lists
A.1 Parameter list
A.1 Parameter list
General
information on the
parameter list
Significance of the parameter numbers (examples)
(refer under the index entry "Parameters – ...)
P1400 Parameter 1400 with sub–parameters
P1401:8 Parameter 1401 with 8 sub–parameters
P0081:64 Parameter 0081 with 64 sub–parameters
Parameter numbers
xxxx word_word word_word word_word (yyy)
Min Standard Max Units
xx xx xx
Units
S
MSR: Dimension system grid
1 MSR = 0.001 mm
1 MSR = 0.0001 inch
1 MSR = 0.001 degrees for P0100 = 3
S
c * MSR
c = 1: for a dimension system mm or
inch
c = 10: for a dimension system, degrees
Example:
P0082:64 = 50 000 [c*MSR/min]
Dimens. system Significance
––> mm
––> inch
––> degrees
Fig. A-1 Parameter list
A-732
Reader's note
The parameters listed in the following are valid for all of the software
releases of "SIMODRIVE 611 universal".
The complete list is updated corresponding to the edition of this
documentation (refer to the edition in the header lines) and
corresponds here to the documented software releases of
"SIMODRIVE 611 universal".
The parameters are designated depending on the particular software
release.
The parameters are listed as follows:
Parameter text
Data type
yy zz
for P0100 = 1
for P0100 = 2
50 mm/min
5 inch/min
500 degrees/min
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Valid for ... motors
none all
SRM rotating synchronous
ARM rotating induction
SLM synchronous linear
Motor dependency
Effective (yyy)
uu
S
RO (Read Only)
can only be read
S
immed. is effective immediately when changed
S
PO POWER ON
when changed, becomes effective after
POWER ON
S
PrgE End of program is
effective if none of the programs
(block processing) are active
S
Vsoll_0 Velocity setpoint zero
Effective for a velocity setpoint = 0
Information on effective
In order that a parameter "immediately" becomes
effective after a change, it may be necessary to
execute the associated function (e.g. P0160
(reference point coordinates) a reference point
approach must be carried out).
E Siemens AG 2005 All Rights Reserved
04.99 01.99
Software release
no data:
... available from SW 2.1
(–> x.y)
e.g.: –> 2.4 :
... available from SW 2.4