Siemens SIMODRIVE 611 universal Function Manual page 135

01.99 08.02
Table 4-3 Diagnostic parameters, continued
No. Name
0600 Operating display
... displays the actual operating status of the unit.
Motor type
Synchr. motor,
standard
Induction mot.,
standard
Induction motor
no encoder,
open–loop contr.
Induction motor,
no encoder,
closed–loop contr.
Synchronous motor,
field–weakening
operation
Synchronous
motor, linear
Operating mode
Drive not
enabled
Closed–loop speed
controlled operation
Open–loop
torque controlled
operation
V/Hz operation
Positioning mode
Point lit
––> PROFIBUS
has
the master function
Point flashes
––>
clock–synchronous
operation active
Freely parameterizable output terminals (standard assignment for n–set)
O3.x: Motor temperature pre–warning
O1.x: Ramp–up completed
O0.x: Ready or no fault
O2.x: | n
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
4.5 Function–initiating and diagnostic parameters
Parameters
Min.
–
Equipment status
All enable signals present,
motoring
All enable signals present,
generating
Setpoint enable missing
(STW1.6)
Ramp–function generator
enable missing
Controller enable
(terminal 64 or 65.x)
missing
Module–specific, pulse
enable (terminal 633) missing
Central enable (terminal 63
or 48) missing
or a fault is present
Power–on inhibit present
Inverter enable missing
(STW1.3)
ON/OFF 1 missing (STW1.0)
Enable/OFF 2 missing
(STW1.1)
Operating condition/OFF 3
missing (STW1.2) or no control
requested (STW1.10)
Drive is inactive or
the parking axis has been selected
Point is lit ––> wait for the signal edge, "motor
changed over" (STW2.11)
| < n
act min
4 Commissioning
Standard Max. Units
– – hex
Parameter set 0 ... 7
Parameterized
speed setpoint source
F: Fixed setpoint
A: Analog
O: Digital
n–set
operating mode
pos
Trav. block
running
Activate
traversing task
(edge)
Intermediate
stop
Reject traversing
task
Referencing running
Reference point still
not approached
Tracking
operation
Jogging 1/2
Override is zero
Traversing to fixed endstop
MDI active
Point lit
––> wait for
an external block
change
Effective
RO
Permanent
coupling
4-135
4