Siemens SIMODRIVE 611 universal Function Manual page 712

7 Fault Handling/Diagnostics
7.3 List of faults and warnings
891
Cause
Remedy
Acknowledgement
Stop response
892
Cause
Remedy
Acknowledgement
Stop response
893
Cause
Remedy
Acknowledgement
Stop response
894
Cause
Remedy
Acknowledgement
Stop response
895
Cause
Remedy
Acknowledgement
Stop response
7-712
PLUS software limit switch actuated coupled
With the actual master drive velocity, this coupling axis will probably
reach or pass the PLUS software limit switch.
This warning is output if the coupled axis has fallen below 200% of the
braking travel up to the PLUS software limit switch.
Traverse the master drive so that this coupling axis goes into the per-
missible traversing range.
not required
STOP VII
MINUS software limit switch actuated coupled
With the actual master drive velocity, this coupling axis will probably
reach or pass the MINUS software limit switch.
This warning is output if the coupled axis has fallen below 200% of the
braking travel up to the MINUS software limit switch.
Traverse the master drive so that this coupling axis goes into the per-
missible traversing range.
not required
STOP VII
Function 73 only effective at terminal I0.x
The terminal function 73 "Coupling on I0" is only effective at terminal
I0.x.
Assign terminal I0.x to function 73.
not required
STOP VII
Inputs, optional TERMINAL module assigned twice
The input terminals on the optional TERMINAL module can only be
used by one drive.
Check and correct P0676 (A) and P0676 (B).
not required
STOP VII
Outputs, optional TERMINAL module assigned twice
Only one drive can use the output terminals on the optional TERMINAL
module.
Check and correct P0696 (A) and P0696 (B).
not required
STOP VII
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
E Siemens AG 2005 All Rights Reserved
04.05 01.99