Siemens SIMODRIVE 611 universal Function Manual page 291

08.99 04.99
Rules regarding The following rules apply to the fault buffer:
the fault buffer
S
S
S
S
Reader's note
A description of the faults, the way in which they can be acknowledged
as well as a list of all the faults, is provided in Chapter 7.
Evaluating The warnings which occurred, are displayed, bit–coded in P0953 to
warnings via P0960.
PROFIBUS–DP
The "SIMODRIVE 611 universal" drive signals as to whether there is at
Status signal for
warnings least one message present via the status bit or output signal ZSW1.7
"Warning present/no warning present".
Reader's note
A description of the warnings as well as a list of all of the warnings is
provided in Chapter 7.
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
5.7
At POWER ON, the complete fault buffer is deleted.
The faults are entered in the sequence that they occur, in the pa-
rameter of fault case 1, i.e.
– 1st fault that has occurred
– 2nd fault that has occurred ––> parameter with index 2, etc.
If more than 8 faults occur, then these are not displayed.
Fault case 1 is considered to have been resolved, if, the following is
valid for all of the entered faults:
– the cause has been removed and
– the fault has been acknowledged
The fault buffer is then re–arranged so that the faults of fault case 1
go into fault case 2 and those from fault case 2 into fault case 3 etc.
This means that the parameters of fault case 1 are again free for
additional entries.
If more than 8 fault cases have occurred since the last POWER ON,
then fault case 8 is overwritten, the oldest fault case is eliminated.
If, in fault case 1, there is at least one fault, which must be acknowl-
edged with POWER ON, then this is valid for the complete fault
case.
5 Communications via PROFIBUS DP
Settings at the PROFIBUS DP master
––> parameter with index 1
5
5-291