Siemens SIMODRIVE 611 universal Function Manual page 784

A Lists
A.1 Parameter list
0915:17 PZD setpoint value assignment PROFIBUS
Min Standard
0 0
... serves for allocating the signals to the process data in the setpoint frame.
The following applies:
P0915:0 no meaning
P0915:1 PZD1, unable to configure (standard setting)
P0915:2 PZD2, Configuring and display of the signal ID (refer to P0922)
P0915:3 PZD3, etc.
ID Significance (abbreviation) (comments)
0 No signal (NIL)
50001 Control word 1 (STW1) (assignment n-set operation)
50001 Control word 1 (STW1) (assignment pos operation)
50003 Control word 2 (STW2)
50005 Speed setpoint A (NSET_A, nset-h) (n-set operation)
50007 Speed setpoint B (NSET_B, nset-(h+l)) (n-set operation)
50009 Encoder 1, control word (G1_STW) (n-set operation)
50013 Encoder 2 control word (G2_STW) (n-set operation, from SW 3.3)
50017 Encoder 3 control word (G3_STW) (n-set operation)
50025 System deviation DSC (XERR) (n set operation, from SW 4.1)
50026 Position controller gain factor DSC (KPC) (n set operation, from SW 4.1)
50101 Torque reduction (MomRed)
50103 Analog output, T. 75.x/15 (DAU1)
50105 Analog output T. 16.x/15 (DAU2)
50107 Digital outputs, T. O0.x to O3.x (DIG_OUT)
50109 Target position for spindle positioning (XSP) (n set operation, from SW 5.1)
50111 Distributed inputs (DezEing) (from SW 4.1)
50113 External torque setpoint (MsollExt) (n set operation, from SW 4.1)
50117 Control word, slave-to-slave communications (QStw)
(pos operation, from SW 4.1)
50201 Block selection (SatzAnw)
50203 Positioning control word (PosStw) (pos operation)
50205 Override (over) (pos operation)
50207 External position reference value (Xext) (pos operation, from SW 4.1)
50209 Correction, external position reference value (XcorExt) (pos operation,
from SW 4.1)
50221 MDI position (MDIPos) (pos mode, from SW 7.1)
50223 MDI velocity (MDIVel) (pos mode, from SW 7.1)
50225 MDI acceleration override (MDIAcc) (pos mode, from SW 7.1)
50227 MDI deceleration override (MDIDec) (pos mode, from SW 7.1)
50229 MDI mode (MDIMode) (pos mode, from SW 7.1)
Note:
If this parameter is read via non-cyclic communication (PROFIdrive), then the indices have
been shifted. Index 1 corresponds to Index 0 (etc.) in the description of the PROFIdrive profile.
Operating mode not specified ––> possible in every operating mode
refer to the index entry "Configuring the process data"
A-784
Max Unit
65535 –
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
! 611ue diff !
Data type Effective
Unsigned16 immed.
E Siemens AG 2005 All Rights Reserved
01.99 04.05
(–> 3.1)