Siemens SIMODRIVE 611 universal Function Manual page 795

01.99 04.05
! 611ue diff !
0986:2 Number list_7
Min Standard
– –
All of the parameter numbers defined in the drive are saved in parameters 980 – 989 from sub-
index 1. The arrays are assigned consecutively without any gaps. If a sub-index contains a
zero, then this is the end of the list of defined parameters. If a sub-index contains the parameter
number of the next list parameter, then the list continues there.
Note:
If this parameter is read via non-cyclic communication (PROFIdrive), then the indices have
been shifted. Index 1 corresponds to Index 0 (etc.) in the description of the PROFIdrive profile.
0987:2 Number list_8
Min Standard
– –
All of the parameter numbers defined in the drive are saved in parameters 980 – 989 from sub-
index 1. The arrays are assigned consecutively without any gaps. If a sub-index contains a
zero, then this is the end of the list of defined parameters. If a sub-index contains the parameter
number of the next list parameter, then the list continues there.
Note:
If this parameter is read via non-cyclic communication (PROFIdrive), then the indices have
been shifted. Index 1 corresponds to Index 0 (etc.) in the description of the PROFIdrive profile.
0988:2 Number list_9
Min Standard
– –
All of the parameter numbers defined in the drive are saved in parameters 980 – 989 from sub-
index 1. The arrays are assigned consecutively without any gaps. If a sub-index contains a
zero, then this is the end of the list of defined parameters. If a sub-index contains the parameter
number of the next list parameter, then the list continues there.
Note:
If this parameter is read via non-cyclic communication (PROFIdrive), then the indices have
been shifted. Index 1 corresponds to Index 0 (etc.) in the description of the PROFIdrive profile.
0989:2 Number list_10
Min Standard
– –
All of the parameter numbers defined in the drive are saved in parameters 980 – 989 from sub-
index 1. The arrays are assigned consecutively without any gaps. If a sub-index contains a
zero, then this is the end of the list of defined parameters. If a sub-index contains the parameter
number of the next list parameter, then the list continues there.
Note:
If this parameter is read via non-cyclic communication (PROFIdrive), then the indices have
been shifted. Index 1 corresponds to Index 0 (etc.) in the description of the PROFIdrive profile.
1000 Current controller cycle
Min Standard
2 4
Current controller clock cycle = P1000 x 31.25 microseconds
Note:
refer to the index entry "Clock cycles"
E Siemens AG 2005 All Rights Reserved
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Max Unit
– –
Max Unit
– –
Max Unit
– –
Max Unit
– –
Max Unit
4 31.25µs
A.1 Parameter list
(–> 6.1)
Data type Effective
Unsigned16 RO
(–> 6.1)
Data type Effective
Unsigned16 RO
(–> 6.1)
Data type Effective
Unsigned16 RO
(–> 6.1)
Data type Effective
Unsigned16 RO
Data type Effective
Unsigned16 PO
A Lists
A
A-795