Siemens SIMODRIVE 611 universal Function Manual page 10

Foreword
x
Edition 02.02 describes the functionality of SW 2.x, SW 3.x,
SW 4.x and SW 5.1.
What are the essential new functions that have been added for
SW 5.1?
S
Spindle positioning
S
Possibility of integrating into an external safety concept "Safe stand-
still"
S
Expanded functionality of the "SimoCom U" start–up tool
– Support, motor data optimization
– Bit masking for the "Trace" function
S
Passive referencing
S
Filter parameterization (current, speed setpoint)
S
"SIMODRIVE 611 universal HR" control board (HR stands for high
resolution)
S
The functionality for "SIMODRIVE 611 universal" described in the
Description of Functions, also applies to "SIMODRIVE 611 universal
HR"
Edition 08.02 describes the functionality of SW 2.x, SW 3.x,
SW 4.x, SW 5.x and SW 6.1.
What are the essential new functions that have been added for
SW 6.1?
S
PROFIdrive conformance
Edition 02.03 describes the functionality of SW 2.x, SW 3.x,
SW 4.x, SW 5.x, SW 6.x and SW 7.1.
What are the essential new functions that have been added for
SW 7.1?
S
MDI (external block processing)
Edition 07.03 describes the functionality of SW 2.x, SW 3.x,
SW 4.x, SW 5.x, SW 6.x and SW 7.
Edition 06.04 describes the functionality of SW 3.6, SW 4.1,
SW 5.x, SW 6.x, SW 7.x and SW 8.1
What are the essential new functions that have been added for
SW 8.1?
S
Electronic handwheel
S
Password protection
S
Any gearbox ratio
S
Changes/modifications for the CAN bus
S
Direction–dependent fast–stop using a hardware switch
Edition 10.04 describes the functionality of SW 3.6, SW 4.1,
SW 5.x, SW 6.x, SW 7.x and SW 8.x
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
E Siemens AG 2005 All Rights Reserved
10.04 06.04