Table of Contents
Advertisement
2 Installing and Connecting-Up
2.1
Installing/removing control boards and modules
Installing/
removing the
memory module
What types of
memory modules
are available?
How is the
memory module
replaced?
!
2-62
The memory module can be replaced, and when supplied from the fac-
tory, a new control board is already installed.
When replacing the control board (service), the memory module can be
transferred from the old control board to the new control board. This
means that the system software can be transferred over with the user
files without requiring any other resources.
There are memory modules for n–set or positioning.
This is labeled at the rear of the memory module:
Designation
before SW 4.2
URL.–SOFTWARE POS.–611U
URL.–SOFTWARE N_SOLL–611U for n–set (refer to Chapter 1.3)
from SW 4.2
SYS.–SOFTWARE POS.–611U
SYS.–SOFTWARE N_SOLL–611U for n–set (refer to Chapter 1.3)
The software designation refers to the system software including
the initial program loader.
A memory module is inserted/replaced as follows:
Warning
The ESDS measures must be observed when installing/removing the
memory module.
1. Place the old and new control boards on an ESDS–compatible sur-
face (to the left of the front panel).
2. Press the memory module latches downwards and outwards until
they release (refer to Fig. 2-2).
3. Remove the memory from its connections (upwards).
4. Insert the
old memory module into the new control board and the new
memory module into the old control board.
The latches must automatically engage.
5. Check that the latches are correctly engaged.
Control board
Latch
Latch
Fig. 2-2
Installing/removing the memory module
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
can be inserted in control board
for positioning (refer to Chap. 1.3)
for positioning (refer to Chap. 1.3)
Slot
for
memory
module
Memory module
E Siemens AG 2005 All Rights Reserved
02.02
01.99
Advertisement
Chapters
Table of Contents
