Siemens SIMODRIVE 611 universal Function Manual page 64

2 Installing and Connecting-Up
2.1 Installing/removing control boards and modules
2-64
– Exit SimoCom U.
– Make a back–up copy of the test file "...\siemens\lists\control.txt"
in the main SimoCom U directory (generally under "C:\Pro-
grams\Siemens\SimoComU").
– Then open this file with Microsoft Wordpad (not with a text edi-
tor!).
– Search for the following line under the Section "611U" or the last
line of this section:
– 6SN1118–1NJ00–0AAx
resolver 1–axis X_SOLL
– Insert the following lines directly below:
– 6SN1118–0NH01–0AA0
encoder HR 2–axis N_SOLL
– 6SN1118–0NK01–0AA0
resolver HR 2–axis N_SOLL
– 6SN1118–0NJ01–0AA0
resolver HR 1–axis N_SOLL
– 6SN1118–1NH01–0AA0
encoder HR 2–axis X_SOLL
– 6SN1118–1NK01–0AA0
resolver HR 2–axis X_SOLL
– 6SN1118–1NJ01–0AA0
resolver HR 1–axis X_SOLL
– As last line, insert under the Section "611UE":
– 6SN1118–0NH11–0AA0
encoder HR 2–axis N_SOLL
– Save the "control.txt" file.
– Restart SimoCom U and continue with Point 6.
6. Save your machine data from the "old" memory module
(File: "*.par") using the "SimoCom U" start–up tool.
7. Again remove the "new" control board and replace the "old" memory
module by the "new" memory module. Software release q SW 5.1
is already installed on the "new" memory module.
8. Insert the "new" control board back into the power module and
tighten the retaining screws (2 screws at the front panel, torque =
0.8 Nm).
9. Re–connect the front panel of the module corresponding to the con-
nection diagram.
Insert the mating connector at the appropriate interface.
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
259 0x00000000 1 1 2 1 ;611U
5 0x00000000 2 2 1 7 ;611U
7 0x00000000 1 2 1 8 ;611U
8 0x00000000 1 1 1 8 ;611U
261 0x00000000 2 2 2 7 ;611U
263 0x00000000 1 2 2 8 ;611U
264 0x00000000 1 1 2 8 ;611U
9 0x00000000 2 2 1 9 ;611UE
E Siemens AG 2005 All Rights Reserved
08.02 02.02 01.99