Configuring The Auto Detect Function For Vrrp - Huawei Quidway S5600 Series Operation Manual

Operation Manual – Auto Detect
Quidway S5600 Series Ethernet Switches-Release 1510
[QuidwayA-detect-group-8]
192.168.1.2
[QuidwayA-detect-group-8] quit
# Enable the static route when the detecting group is reachable. Disable th
route when the detecting group is unreachable.
[QuidwayA] ip route-static 10.1.1.4 24 192.168.1
2.3 Aut o Detect Implementation in VRRP
You can control the priorities of VRRP backup groups according to auto detect results
to en able automatic switch b
Decrease the priority of a VRRP backup group when the result of the detecting
group is unreachabl
Resume the priority of a VRRP backup group when the result of the detecting
group is reachable.

2.3.1 Configuring the Auto Detect Function for VRRP

Note:
You need to create the detecting group and perform VRRP-related configurations
b efore the following operations.
Table 2-2
Operation
Enter system view
Enter
interface view
Enable the auto
detect function for
VRRP
2.3.2 Co nfiguration Example
I. Netw ork requirements
Switch B and switch D form VRRP backup group 1, whose virtual IP address is
192.168.1.10.
detec
etween the master and the backup switch as follows:
e.
Config ure the auto detect functio for VRRP
Command
system -view
VLAN interface
vlan-id
Vrrp vrid virtu
track
group-number
value-reduced ]
Huawei Technologies Proprietary
Chapter 2 Auto Detect Implementation
t-list 1 ip address
.2 detect-group 8
n
—
vlan-interface
—
al-route r-id
detect-grou p
Required
[ reduced
2-3
10.1.1.4 nexthop
e static
Description