Optional) Setting The Default Preference For Ipv4 Static Routes; Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
----End
1.3.3 (Optional) Setting the Default Preference for IPv4 Static
Routes
Setting the default preference for IPv4 static routes can affect route selection.
Context
Do as follows on the switches that need to be configured with static routes and change the default
preference for static routes:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip route-static default-preference preference
The default preference is set for static routes.
By default, the preference of static routes is 60.
When a static route is configured, the default preference is used if no preference is explicitly
specified for the static route. After a default preference is specified, the new default preference
is valid for subsequent rather than existing IPv4 static routes.
----End

1.3.4 Checking the Configuration

After an IPv4 static route is configured, you can check detailed information about the configured
IPv4 static route.
Prerequisites
The configurations for an IPv4 static route are complete.
Procedure
l
l
----End
Issue 01 (2012-03-15)
NOTE
If you configure the next hop as the outbound interface, you must specify the next hop address.
Run the display ip routing-table command to check brief information about the IPv4
routing table.
Run the display ip routing-table verbose command to check detailed information about
the IPv4 routing table.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Static Route Configuration
5