Dlp-G78 Verify The 32Mux-O And 32Dmx-O Power; Dlp-G79 Verify The Opt-Bst Amplifier Laser And Power - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G78 Verify the 32MUX-O and 32DMX-O Power

DLP-G78 Verify the 32MUX-O and 32DMX-O Power
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Display the 32MUX-O in card view.
Step 2 Click the Provisioning > Optical Chn > Parameters tabs.
Change the Admin State of the correspondent port to OOS,MT/Locked,maintenance.
Step 3
Check that the power value on the port reaches the provisioned setpoint (VOA Power Ref).
Step 4
Display the east 32DMX-O in card view.
Step 5
Click the Provisioning > Optical Chn > Parameters tabs.
Step 6
Change the Admin State of correspondent port to OOS,MT/Locked,maintenance.
Step 7
Check that the power value on the port reaches the provisioned setpoint (VOA Power Ref).
Step 8
Click the Provisioning > Opt Ampli Line > Parameters tabs.
Step 9
Step 10 Return to your originating procedure (NTP).

DLP-G79 Verify the OPT-BST Amplifier Laser and Power

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the OPT-BST amplifier to display the card view.
Step 1
If the Laser Status displayed in the information area is "On" continue with
Step 2
following steps:
a.
b.
c.
Click the Provisioning > Opt Ampli Line > Parameters tabs.
Step 3
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
4-22
This task verifies 32MUX-O and 32DMX-O power.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser only
This task verifies that the OPT-BST amplifier laser is on and provisioned
to the correct power.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser only
Click the Maintenance > ALS tabs.
Check the OSRI setting. If it is set to On, change it to Off and click Apply.
Check the Laser Status. If it changes to On, continue with
support. The amplifier might need to be replaced.
Chapter 4 Perform Node Acceptance Tests
Step 3. If not, complete the
Step 3. If not, contact your next level of
September 2004