Dlp-G136 Clear Selected Pm Counts; Dlp-G137 Set Auto-Refresh Interval For Displayed Pm Counts - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G136 Clear Selected PM Counts

DLP-G136 Clear Selected PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Pressing the Clear button can mask problems if used incorrectly. This button is commonly used for
Caution
testing purposes. After pressing this button, the current bin is marked invalid. Also note that the
unavailable seconds (UAS) count is not cleared if you were counting UAS; therefore, this count could
be unreliable when you press Clear.
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Step 3 Click Clear.
Step 4 From the Clear Statistics dialog box, click one of the following radio buttons:
•
•
•
From the Clear Statistics dialog box, click OK to clear the selected statistics.
Step 5
Verify that the selected PM counts have been cleared.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-G137 Set Auto-Refresh Interval for Displayed PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
8-6
Displayed statistics: Clearing displayed statistics erases all PM counts associated with the current
combination of statistics on the selected port from the card and the window. This means that the
selected time interval, direction, and signal type counts are erased from the card and the window.
All statistics for port x: Clearing all statistics for port x erases all PM counts associated with all
combinations of the statistics on the selected port from the card and the window. This means that all
time intervals, directions, and signal type counts are erased from the card and the window.
All statistics for card: Clearing all statistics for card erases all PM counts for all ports from the card
and the window.
This task uses the Clear button to clear specified PM counts depending
on the option selected.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
This task changes the window auto-refresh intervals for updating the
displayed PM counts.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 8 Monitor Performance
September 2004