Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

Create Channels and Circuits
This chapter explains how to create Cisco ONS 15454 dense wavelength division multiplexing (DWDM)
optical channel network connections (OCHNCs) and overhead circuits.
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note

Before You Begin

Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
September 2004
NTP-G58 Locate and View Optical Channel Network Connections, page
to find, view, and filter OCHNCs.
NTP-G59 Create and Delete Optical Channel Network Connections, page
needed.
NTP-G60 Create Overhead Circuits, page
tunnels, provision orderwire, or user data channel (UDC) circuits.
NTP-G61 Modify and Delete Overhead Circuits, page
circuits and delete overhead circuits.
NTP-G62 Create a J0 Section Trace, page
changes to traffic between two nodes.
C H A P T E R
6-12—Complete as needed to create IP-encapsulated
6-17—Complete as needed to repair IP
6-18—Complete as needed to monitor interruptions or
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
6
6-2—Complete as needed
6-8—Complete as
6-1