Cisco ONS 15454 DWDM Installation And Operation Manual page 446

DLP-G206 Change Optical Amplifier Line Settings for OPT-PRE and OPT-BST Amplifiers
Table 10-8 OPT-PRE and OPT-BST Optical Amplifier Line Settings (continued)
Parameter Description
Type Identifies the type of port. Display only.
Power Shows the current power level per port. Display
only.
Power Ref. Shows the optical power per channel leaving to the
amplifier. Display only.
Power Calib. The user can manually set the total optical power
going to the amplifiers.
Gain The current gain of the amplifiers. Display only.
Gain Set Point The value of the gain that the amplifier must
achieve.
Tilt Reference This field is set to zero. It represents the default
value for the amplifier tilt. In a future software
release this value will be managed by APC.
Display only.
Tilt Calibration The user can manually set the amplifier tilt.
Mode Shows the working mode of the amplifier. Display
only.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-14
Options
• Input Com
• Output Com
Input Line
•
Output Line
•
Input OSC
•
Output OSC.
•
—
—
Numeric
—
Display only or numeric depending on mode setting.
When the system is configured as metro core, this field
is Display only. When the system is configured as metro
access this field can be changed by the user.
—
Numeric
Control gain
Control power
Chapter 10 Change Card Settings
September 2004