Appendix B
Hardware Specifications
•
B.3.5 MIC-C/T/P FMEC Specifications (ETSI only)
The ONS 15454 ANSI does not support the MIC-C/T/P FMEC.
Note
•
•
•
•
•
•
April 2006
–
Weight not including clam shell: 0.2 kg (0.5 lb)
Compliance: Installed ONS 15454 ETSI cards comply with these safety standards:
IEC 60950, EN 60950, UL 60950, CSA C22.2 No. 60950, TS 001, AS/NZS 3260
–
Power supply input BATTERY A
System supply voltage: Nominal –48 VDC
–
Tolerance limits: –40.5 to –57.0 VDC
Connector: 3WK3 Combo-D power cable connector
–
Timing connector
Frequency: 2.048 MHz +/–10 ppm
–
Signal level: 0.75 to 1.5 V
–
Impedance: 75 ohms +/–5% (switchable by jumper to high impedance > 3 kohms)
–
120 ohms balanced impedance is possible with external matching cable.
Note
Cable attenuation: Up to 6 dB at 2 MHz
–
Connectors: 1.0/2.3 miniature coax connector
–
System management serial port:
–
System management serial port craft interface
–
Modem port (for future use)
Connectors: 8-pin RJ-45
–
System management LAN port connectors:
Signal: IEEE 802.3 10BaseT
–
Connectors: 8-pin RJ-45
–
Environmental
Operating temperature: –5 to +45 degrees Celsius (+23 to +113 degrees Fahrenheit)
–
Operating humidity: 5 to 95%, noncondensing
–
Power consumption: 0.38 W (provided by +5 V from the TCC2 card), 1.37 BTU/hr
–
Dimensions
Height: 182 mm (7.165 in.)
–
Width: 32 mm (1.25 in.)
–
Depth: 92 mm (3.62 in.)
–
Depth with backplane connector: 98 mm (3.87 in.)
–
Weight not including clam shell: 0.2 kg (0.5 lb)
–
B.3.5 MIC-C/T/P FMEC Specifications (ETSI only)
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
B-11