Dlp-G162 Change Ip Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Manage the Node
Step 3 Perform any of the following tasks as needed:
•
•
•
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.

DLP-G162 Change IP Settings

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2s to reboot. If Ethernet
Caution
circuits using Spanning Tree Protocol (STP) originate or terminate on E-Series Ethernet cards installed
in the node, circuit traffic will be lost for several minutes while the spanning trees reconverge. Other
circuits are not affected by TCC2 reboots.
In node view, click the Provisioning > Network > General tabs.
Step 1
Step 2 Change any of the following:
•
•
•
•
•
•
•
•
September 2004
DLP-G162 Change IP Settings, page 9-11
DLP-G163 Modify a Static Route, page 9-12
DLP-G164 Delete a Static Route, page 9-13
DLP-G165 Disable OSPF, page 9-13
DLP-G59 Set Up or Change Open Shortest Path First Protocol, page 3-16
DLP-G166 Delete a Proxy Tunnel, page 9-14
DLP-G167 Delete a Firewall Tunnel, page 9-14
"NTP-G103 Back Up the Database" procedure on page
This task changes the IP address, subnet mask, default router, DHCP
access, firewall IIOP listener port, LCD IP display, and proxy server
settings.
None
DLP-G46 Log into CTC, page 2-25
DLP-G56 Provision IP Settings, page 3-9
As needed
Onsite or remote
Superuser
IP Address
Suppress CTC IP Display
LCD IP Setting
Default Router
Forward DHCP Request To
MAC Address
Net/Subnet Mask Length
TCC CORBA (IIOP) Listener Port
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G162 Change IP Settings
11-2.
9-11