Txp_Mr_10G Port-Level Indicators; Table 14-48 Txp_Mr_10G Card-Level Indicators; Table 14-49 Txp_Mr_10G Port-Level Indicators - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 14 Card Reference

Table 14-48 TXP_MR_10G Card-Level Indicators

Card-Level LED
FAIL LED (Red)
ACT/STBY LED
Green (Active)
Amber (Standby)
SF LED (Amber)

14.8.1.3 TXP_MR_10G Port-Level Indicators

Table 14-51

Table 14-49 TXP_MR_10G Port-Level Indicators

Port-Level LED
Green Client LED
Green DWDM LED
Green Wavelength 1 LED
Green Wavelength 2 LED
December 2004
Description
Red indicates that the card's processor is not ready. This LED is on during
reset. The FAIL LED flashes during the boot process. Replace the card if the
red FAIL LED persists.
Green indicates that the card is operational (one or both ports active) and
ready to carry traffic.
Amber indicates that the card is operational and in standby (protect) mode.
Amber indicates a signal failure or condition such as LOS, LOF, or high
BERs on one or more of the card's ports. The amber SF LED is also
illuminated if the transmit and receive fibers are incorrectly connected. If the
fibers are properly connected and the link is working, the LED turns off.
lists the four port-level LEDs in the TXP_MR_10G card.
Description
The green Client LED indicates that the client port is in service and that it is
receiving a recognized signal.
The green DWDM LED indicates that the DWDM port is in service and that
it is receiving a recognized signal.
Each port supports two wavelengths on the DWDM side. Each wavelength
LED matches one of the wavelengths. This LED indicates that the card is
configured for Wavelength 1.
Each port supports two wavelengths on the DWDM side. Each wavelength
LED matches one of the wavelengths. This LED indicates that the card is
configured for Wavelength 2.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
14.8.1 TXP_MR_10G Card
14-89