Dlp-G203 Change Maintenance Settings For Automatic Laser Shutdown; Table 10-5 Osc-Csm, Oscm, Or Opt-Bst Amplifier Maintenance Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings

DLP-G203 Change Maintenance Settings for Automatic Laser Shutdown

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the OSC-CSM, OSCM, or OPT-BST amplifier where you want to change the
ALS maintenance settings.
Step 2 Click the Maintenance > ALS tabs.
Step 3 Modify any of the settings described in
Table 10-5
Parameter
OSRI
ALS Mode
Recovery Pulse
Duration
Recovery Pulse
Interval
Currently
Shutdown
Request Laser
Restart
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
September 2004
This task changes the maintenance settings for the automatic laser
shutdown (ALS) feature on the OSC-CSM, OSCM, and OPT-BST
amplifier cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
OSC-CSM, OSCM, or OPT-BST Amplifier Maintenance Settings
Description
Optical safety remote interlock. Shuts
down the optical output power. When set
to On, the amplifier cannot be
unknowingly turned on.
Automatic laser shutdown. Provides the
ability to automatically shut a potentially
hazardous laser off.
Displays the duration of the optical power
pulse that begins when an amplifier
restarts. Display only.
Displays the interval between optical
power pulses. Display only.
Displays the current status of the laser.
Display only.
If checked, allows you to restart the laser.
Display only.
DLP-G203 Change Maintenance Settings for Automatic Laser Shutdown
Table 10-5.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Options
On and off
• Disable
Auto Restart
•
Manual Restart
•
Manual Restart for Test
•
—
—
—
Checked or unchecked
10-9