Dlp-G75 Create Osc Terminations; Figure 3-18 Osc Terminations Pane - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node

DLP-G75 Create OSC Terminations

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Comm Channels > OSC tabs.
Step 1
In the OSC Terminations pane, click Create
Step 2

Figure 3-18 OSC Terminations Pane

Comm Channels
In the Create OSC Terminations dialog box, choose the ports where you want to create the OSC
Step 3
termination. To select more than one port, press the Shift key (to select a range of ports) or the Ctrl key
(to select multiple individual ports).
Note
September 2004
This task creates the terminations required by OSC channels between
network nodes.
None
NTP-G36 Calculate Cable Connections, page 3-56
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Provisioning
tab tab
OSC on the DWDM node uses a separate OC3/STM1 channel to transport the section data
communications channel (SDCC), which is used for ONS 15454 DCC terminations.
(Figure 3-18).
Create OSC Terminations
dialog box
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G75 Create OSC Terminations
3-61