Dlp-G234 Change Otn Settings For Txp_Mr_2.5G And Txpp_Mr_2.5G Cards; Table 10-43 Txp_Mr_2.5G And Txpp_Mr_2.5G Transponder Card Optics Thresholds Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards

Table 10-43 TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Optics Thresholds Settings

Parameter
Port
Laser Bias
Low (%)
RX Power
High (dBm)
RX Power Low
(dBm)
TX Power
High (dBm)
TX Power Low
(dBm)
Click Apply.
Step 4
Click the Alarm radio button and click Refresh.
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-G234 Change OTN Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
Step 1
OTN settings.
Click one of the Provisioning > OTN tabs (OTN Lines, G.709 Thresholds, FEC Thresholds, or Trail
Step 2
Trace Identifier tab).
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-62
Description
Display only. Displays the port number.
Sets the warning threshold for low laser
bias current.
Sets the warning threshold for high
receiver input power.
Sets the warning threshold for low
receiver input power.
Sets the warning threshold for high
transmitter output power.
Sets the warning threshold for low
transmitter output power.
This task changes the OTN settings for TXP_MR_2.5G and
TXPP_MR_2.5G transponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 10 Change Card Settings
Options
1
•
2
•
3 (TXPP_MR_2.5G only)
•
Numeric, in percent
Range 0 to 100 (client side)
Range 0 to 100 (trunk side)
Numeric, in dBm
Range –40.0 to +30.0 (client side)
Range –40.0 to +30.0 (trunk side)
Numeric, in dBm
Range –40.0 to +30.0 (client side)
Range –40.0 to +30.0 (trunk side)
Numeric, in dBm
Range –40.0 to +30.0 (client side)
Not applicable (trunk side)
Numeric, in dBm
Range –40.0 to +30.0 (client side)
Not applicable (trunk side)
September 2004