Dlp-G207 Change Optical Channel Threshold Settings For Opt-Pre And Opt-Bst Amplifiers; Table 10-9 Opt-Pre And Opt-Bst Amplifier Optical Channel Threshold Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
DLP-G207 Change Optical Channel Threshold Settings for OPT-PRE and
OPT-BST Amplifiers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the OPT-PRE or OPT-BST amplifier where you want to change the optical
Step 1
channel threshold settings.
Step 2 Click the Provisioning > Opt. Ampli. Line > Optics Thresholds tabs.
Modify any of the settings described in
Step 3

Table 10-9 OPT-PRE and OPT-BST Amplifier Optical Channel Threshold Settings

Parameter
Port
Power Low
(dBm)
Power High
(dBm)
Click Apply.
Step 4
Step 5 Return to your originating procedure (NTP).
September 2004

DLP-G207 Change Optical Channel Threshold Settings for OPT-PRE and OPT-BST Amplifiers

This task changes the optical channel threshold settings for OPT-PRE and
OPT-BST amplifier cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Description
Display only. Displays the port number.
Set the low power settings.
Set the high power settings.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-9.
Options
—
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
Numeric. Can be set for 15-minute or
one-day intervals for Warning or Alarm.
Select the bullet and click Refresh.
10-15