Connect The Pc And Log Into The Gui; Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

Connect the PC and Log into the GUI

This chapter explains how to connect PCs and workstations to the Cisco ONS 15454 and how to log into
Cisco Transport Controller (CTC) software, which is the ONS 15454 Operation, Administration,
Maintenance and Provisioning (OAM&P) user interface. Procedures for connecting to the ONS 15454
ANSI using TL1 are provided in the Cisco ONS 15454 and Cisco ONS 15327 TL1 Command Guide,
Release 4.6.
Unless otherwise specified, "ONS 15454" refers to both ANSI and ETSI shelf assemblies.
Note

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
September 2004
NTP-G17 Set Up Computer for CTC, page
has never been connected to an ONS 15454.
NTP-G18 Set Up CTC Computer for Local Craft Connection to the ONS 15454, page
2-9—Complete this procedure to set up your computer for an onsite craft connection to the
ONS 15454.
NTP-G19 Set Up a CTC Computer for a Corporate LAN Connection to the ONS 15454, page
2-20—Complete this procedure to set up your computer to connect to the ONS 15454 using a
corporate LAN.
NTP-G20 Set Up a Remote Access Connection to the ONS 15454, page
procedure to set up your computer for remote modem access to the ONS 15454.
NTP-G21 Log into the ONS 15454 GUI, page
C H A P T E R
2-2—Complete this procedure if your PC or workstation
2-23—Complete this procedure to log into CTC.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
2
2-22—Complete this
2-1