Ntp-G94 Provision Pluggable Port Modules - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
Step 7 Click the Refresh button.
Return to your originating procedure (NTP).
Step 8

NTP-G94 Provision Pluggable Port Modules

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
Click the Alarms tab:
Step 2
a.
b.
c.
In node view, double-click the card where you want to provision PPM settings.
Step 3
Click the Provisioning > Pluggable Port Modules tabs.
Step 4
In the Pluggable Port Modules pane, click Create. The Create PPM dialog box appears.
Step 5
In the Create PPM dialog box, complete the following:
Step 6
•
•
Click OK. The newly created port appears in the Pluggable Port Modules pane and the Pluggable Ports
Step 7
pane.
Repeat Steps
Step 8
Click the PPM port row that appears in the Pluggable Port Modules pane. The highlight changes to dark
Step 9
blue.
In the Selected PPM pane, click Create. The Create Port dialog box appears.
Step 10
In the Create Port dialog box, complete the following:
Step 11
September 2004
This procedure provisions pluggable port modules (PPMs) such as Small
Form-factor Pluggables (SFPs) for TXP and MXP cards. Only the
TXP_MR_10G does not accept PPMs.
None
NTP-G32 Install the Transponder and Muxponder Cards, page 3-30
DLP-G63 Install an SFP, page 3-32
Required
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
Verify that the alarm filter is not turned on. See the
page 7-32 as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 SONET and DWDM Troubleshooting
Guide.
Complete the "DLP-G114 Export CTC Data" task on page 7-4
information.
PPM—Click the slot number where the SFP is installed from the drop-down list.
PPM Type—Click the number of ports supported by your SFP from the drop-down list. If only one
port is supported, PPM (1 port) is the only menu option.
5 through 7 to create as many ports as needed.
to log into an ONS 15454 on the network.
"DLP-G128 Disable Alarm Filtering" task on
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
NTP-G94 Provision Pluggable Port Modules
to export alarm and condition
10-29