Cisco ONS 15454 DWDM Installation And Operation Manual page 456

DLP-G212 Change Optical Channel Parameters for the 32WSS Card
Table 10-14 32WSS Optical Channel Parameter Settings (continued)
Parameter Description
Line Direction Display only. Displays the direction that the
optical signal flows.
Type Port type
Power Power value read by the photodiode after the
VOA.
VOA Mode Displays VOA power mode.
VOA Power Display only. Displays VOA power reference.
Reference
VOA Power Displays VOA power calibration.
Calibration
VOA Display only. Displays VOA attenuation
Attenuation reference.
Reference
VOA Displays VOA attenuation calibration.
Attenuation
Calibration
Actual Display only. Displays the actual wavelength
Wavelength utilized by the channel.
Expected Display only. Displays the expected wavelength
Wavelength assigned for the channel.
Power ADD Display only. Displays Power Add, which is the
value read by the photodiode before the VOA.
Applicable only for ADD channels.
Path Value Display only. Displays Path value.
AINS Soak Display only. Sets the automatic in-service soak
period.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
10-24
Options
• West to East (the direction in which channels are
added)
East to West (the direction in which channels are
•
dropped)
Add
•
Passthrough
•
Numeric value (dB)
•
• Constant Power
Numeric value (dB)
•
Numeric value (dB)
•
–37 dB to –2 dB
•
Numeric value (dB)
•
Numeric value (dB)
•
• –30 dB to +30 dB
Actual measured value (nm)
•
UNKNOWN
•
Value (nm) from the ITU-T grid specification
•
UNKNOWN
•
Numeric value (dB)
•
Standby
•
Duration of valid input signal, in hh.mm format, after
•
which the card becomes in service (IS) automatically
0 to 48 hours, 15-minute increments
•
Chapter 10 Change Card Settings
September 2004