Table 10-49 Mxp_Mr_2.5G And Mxpp_Mr_2.5G Muxponder Card Line Client Tab Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
DLP-G236 Change Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
line settings.
Click the Provisioning > Line > tab and any additional tabs (Client, Distance Extension, OC48, Section
Step 2
Trace, and so on). Tabs and parameter selections vary according to PPM provisioning.
Step 3 Modify any of the settings for the Client tab as described in

Table 10-49 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line Client Tab Settings

Parameter Description
Port # Display only. Displays the port number.
Port Name The user can assign a logical name for each of the
ports shown by filling in this field.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Enhanced State Model."
September 2004
DLP-G236 Change Line Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
This task changes the line settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Options
1
•
2
•
3
•
4
•
5
•
6
•
• 7
• 8
9 (trunk for MXP_MR_2.5G) or 9-10 (trunk for
•
MXPP_MR_2.5G)
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default.
See the
page 6-8.
• IS/Unlocked
IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Table 10-49.
"DLP-G104 Assign a Name to a Port" task on
10-67