Dlp-G35 Inspect The Shelf Installation And Connections; Table 1-13 Ons 15454 Ansi Shelf Installation Task Summary - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP- G35 Inspect the Shelf Installation and Connections

Table 1-13 ONS 15454 ANSI Shelf Installation Task Summary

Description
NTP-G1 Unpack and Inspect the Shelf Assembly, page 1-6
NTP-G2 Install the Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-20
NTP-G5 Remove the Backplane Covers (ANSI Only), page 1-26
NTP-G7 Install the Power and Ground, page 1-30
NTP-G8 Install the Fan-Tray Assembly, page 1-40
NTP-G9 Install the Alarm Expansion Panel (ANSI Only), page 1-44
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
1-47
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only), page 1-59
NTP-G13 Install the Rear Cover (ANSI Only), page 1-65
NTP-G14 Install DWDM Equipment, page 1-66
NTP-G15 Install the Common Control Cards, page 1-72
Complete the
Step 3
Complete the
Step 4
Continue with
Step 5
Stop. You have completed this procedure.

DLP-G35 Inspect the Shelf Installation and Connections

Purpose
Tools/Equipment
Prerequisite Procedures Complete
Required/As Needed
Onsite/Remote
Security Level
Check each wire and cable connection to make sure all cables are locked securely. If a wire or cable is
Step 1
loose, return to the appropriate procedure in this chapter to correct it.
To check that the front door is seated correctly, verify that it can be easily closed without disturbing fiber
Step 2
or Ethernet patch cords.
To check that the FMEC cover is seated correctly, verify that it can be easily closed without disturbing
Step 3
cables.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
1-78
"DLP-G35 Inspect the Shelf Installation and Connections" task on page
"DLP-G36 Measure Voltage" task on page
Chapter 2, "Connect the PC and Log into the GUI."
Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly.
None
Table 1-12 on page 1-77
(ANSI).
Required
Onsite
None
Chapter 1 Install the Shelf and Common Control Cards
1-79.
(ETSI) or Table 1-13 on page 1-78
Completed
1-78.
September 2004