Dlp-G109 Provision Orderwire - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 6 Create Channels and Circuits
Step 5 Click Apply. The new port service state appears in the Service State column.
As needed, repeat this task for each port.
Step 6
Return to your originating procedure (NTP).
Step 7

DLP-G109 Provision Orderwire

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In the network view, click the Provisioning > Overhead Circuits tabs.
Click Create.
Step 2
In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:
Step 3
•
•
•
Caution When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Click Next.
Step 4
In the Circuit Source area, complete the following:
Step 5
•
•
•
Click Next.
Step 6
September 2004
This task provisions orderwire on the AIC or the AIC-I card.
An AIC or AIC-I card must be installed in Slot 9.
An OSCM, OSC-SCM, MXP_2.5_10E, MXP_2.5_10G,
MXPP_MR_2.5G, or MXP_MR_2.5G card must be installed.
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces).
Circuit Type—Choose either Local Orderwire or Express Orderwire depending on the orderwire
path that you want to create. If regenerators are not used between ONS 15454 nodes, you can use
either local or express orderwire channels. If regenerators exist, use the express orderwire channel.
You can provision up to four ONS 15454 OC-N ports for each orderwire path.
PCM—Choose the Pulse Code Modulation voice coding and companding standard, either Mu_Law
(North America, Japan) or A_Law (Europe). The provisioning procedures are the same for both
types of orderwire.
Node—Choose the source node.
Slot—Choose the source slot.
Port—If displayed, choose the source port.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G109 Provision Orderwire
6-15