Dlp-G93 Verify Add And Drop Connections On Oadm Node With Oscm Card - Cisco ONS 15454 DWDM Installation And Operation Manual

Hide thumbs Also See for ONS 15454 DWDM:
Table of Contents

Advertisement

Chapter 4
Perform Node Acceptance Tests
b.
c.
Step 6
Verify the east 4MD-xx.x (west-to-east):
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 7

DLP-G93 Verify Add and Drop Connections on OADM Node with OSCM Card

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In this task, you will verify add and drop connections in the following order: east-to-west add and
Note
west-to-east drop, Steps
Step 1
From the Cisco MetroPlanner site configuration file, identify the wavelength (belonging to the 100-GHz
ITU-T grid) of the channel running on the first add path of the first west AD-xC-xx.x or west 4MD-xx.x
card on the east-to-west direction.
Connect the tunable laser to the corresponding 15xx.x RX port (on the card front panel) of the west
Step 2
AD-xC-xx.x or 4MD-xx.x card.
Step 3
Verify the west AD-xC-xx.x or 4MD-xx.x (east-to-west):
a.
b.
c.
d.
Step 4
Complete the
OPT-BST amplifier to verify that the added wavelength turns on the laser.
September 2004
Click the Provisioning > Optical Chn > Parameters tabs.
Verify that the Power value on the CHAN TX port is higher than the default no-power value of
–35 dBm.
Display the east 4MD-xx.x card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
Change the Admin State of the CHAN RX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength selected on the tunable laser.
Verify that the Power value of the CHAN RX port reaches the provisioned setpoint (VOA Power
Ref).
This task verifies the add and drop channel connections for an OADM node
with OSCM cards installed.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser only
1
through 15; west-to-east add and east-to-west drop, Steps
Display the west AD-xC-xx.x or 4MD-xx.x card in card view.
Click the Provisioning > Optical Chn > Parameters tabs.
Change the Admin State of the CHAN RX port to OOS,MT/Locked,maintenance for the channel
related to the wavelength chosen on the tunable laser.
Verify that the Power value of the CHAN RX port reaches the provisioned setpoint (VOA Power
Ref).
"DLP-G79 Verify the OPT-BST Amplifier Laser and Power" task on page 4-22
DLP-G93 Verify Add and Drop Connections on OADM Node with OSCM Card
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
16
through
17
on the west
4-33

Advertisement

Table of Contents
loading

Table of Contents