Dlp-G108 Change The Service State For A Port - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G108 Change the Service State for a Port

Step 10 Return to your originating procedure (NTP).
DLP-G108 Change the Service State for a Port
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view on the shelf graphic, double-click the card with the port(s) you want to put in or out of
Step 1
service. The card view appears.
Click the Provisioning > Line tabs.
Step 2
In the Admin State column for the desired port, choose one of the following from the drop-down list:
Step 3
•
•
•
•
For more information about service states, refer to
Step 4 If you set the Admin State to IS-AINS/Unlocked,automaticInService, set the soak period time in the
AINS Soak field. This is the amount of time that the port will stay in the
OOS-AU,AINS/Unlocked-enabled,automaticInService service state after a signal is continuously
received. When the soak period elapses, the port changes to the IS-NR/Unlocked-enabled service state.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
6-14
This task puts a port in service or removes a port from service. After
creating an IP-encapsulated tunnel, put the ports that are hosting the
IP-encapsulated tunnel in service.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
IS (ANSI) or Unlocked (ETSI)—Places the port in the IS-NR (ANSI) or Unlocked-enabled (ETSI)
service state.
OOS, DSBLD (ANSI) or Locked,disabled (ETSI)—Places the port in the
OOS-MA,DSBLD (ANSI) or Locked-enabled,disabled (ETSI) service state.
For ANSI nodes, traffic is not passed on the port until the service state is changed to IS-NR;
OOS-MA,MT; or Out-of-Service and Autonomous, Automatic In-Service (OOS-AU,AINS). For
ETSI nodes, traffic is not passed on the port until the service state is changed to Unlocked-enabled;
Locked-enabled,maintenance; or Unlocked-disabled,automaticInService.
OOS, MT (ANSI) or Locked,maintenance (ETSI)—Places the port in the
OOS-MA,MT/Locked-enabled,maintenance service state. This service state does not interrupt
traffic flow, but alarm reporting is suppressed and loopbacks are allowed. Raised fault conditions,
whether or not their alarms are reported, can be retrieved on the CTC Conditions tab or by using the
TL1 RTRV-COND command. Use the OOS-MA,MT/Locked-enabled,maintenance service state for
testing or to suppress alarms temporarily. Change to the IS-NR/Unlocked-enabled or
OOS-AU,AINS/Unlocked-disabled,automaticInService service states when testing is complete.
IS, AINS (ANSI) or Unlocked,automaticInService (ETSI)—Places the port in the
OOS-AU,AINS/Unlocked-enabled,automaticInService service state. In this service state, alarm
reporting is suppressed, but traffic is carried and loopbacks are allowed. After the soak period
passes, the port changes to IS-NR/Unlocked-enabled. Raised fault conditions, whether their alarms
are reported or not, can be retrieved on the CTC Conditions tab or by using the TL1 RTRV-COND
command.
Chapter 6
Appendix C, "DWDM Enhanced State Model."
Create Channels and Circuits
September 2004