Dlp-G226 Change Line Thresholds Settings For Mxp_2.5G_10G And Mxp 2.5G_10E Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Change Card Settings
Table 10-31 TXP_MR_10G and MXP_MR_10E Muxponder Card Trunk Settings (continued)
Parameter Description
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service states
appear in the format: Primary State-Primary State
Qualifier, Secondary State. For more information
about service states, see
Enhanced State Model."
ALS Mode Sets the automatic laser shutdown function mode.
The DWDM transmitter supports ALS according to
ITU-T G.644 (06/99). ALS can be disabled or be set
for three mode options.
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP
2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
Step 1
line threshold settings.
Step 2 Click the Provisioning > Line Thresholds tabs.
Step 3 Modify any of the settings described in
September 2004

DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP 2.5G_10E Cards

Appendix C, "DWDM
This task changes the line threshold settings for MXP_2.5G_10G or
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
Options
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
• OOS-MA,DSBLD/Locked-enabled,disabled
• OOS-MA,MT/Locked-enabled,maintenance
Disable: ALS is off; the laser is not
•
automatically shut down when traffic outages
(LOS) occur.
Auto Restart: ALS is on; the laser automatically
•
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
Manual Restart: ALS is on; the laser
•
automatically shuts down when traffic outages
(LOS) occur. However, the laser must be
manually restarted when conditions that caused
the outage are resolved.
Manual Restart for Test: Manually restarts the
•
laser for testing.
10-32.
10-49