Dlp-G135 Reset Current Pm Counts - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 8 Monitor Performance
Step 2 Click the Performance tab.
Click the Far End radio button.
Step 3
Click Refresh. All PM parameters recorded by the far-end node for the selected card on the outgoing
Step 4
signal appear. For PM parameter definitions, refer to the Cisco ONS 15454 SONET and DWDM
Troubleshooting Guide.
View the Curr column to find PM counts for the current time interval.
Step 5
View the Prev-n columns to find PM counts for the previous time intervals.
Step 6
Step 7 Return to your originating procedure (NTP).

DLP-G135 Reset Current PM Counts

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card where you want to view PM counts. The card view appears.
Step 1
Click the Performance tab.
Step 2
Click Baseline.
Step 3
Note
Step 4 View the current statistics columns to observe changes to PM counts for the current time interval.
Return to your originating procedure (NTP).
Step 5
September 2004
This task clears the current PM count, but it does not clear the
cumulative PM count. This task allows you to see how quickly PM
counts rise.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
The Baseline button clears the PM counts displayed in the current time interval but does not clear
the PM counts on the card. When the current time interval expires or the window view changes,
the total number of PM counts on the card and on the window appears in the appropriate column.
The baseline values are discarded if you change views to a different window and then return to
the Performance window.
Cisco ONS 15454 DWDM Installation and Operations Guide, R4.7
DLP-G135 Reset Current PM Counts
8-5